In the end you may need to completely replace the opener lights.
Light will not go off on garage door opener.
If you are experiencing problems with the interior light on your genie garage door opener you can run through some troubleshooting steps to try and resolve common faults.
If your genie garage door light will not switch off it could be a problem with the wiring or hardware.
A simple way to do this is to unplug the garage door opener and then plug in another device say your phone or a light bulb to see if it lights up.
See safe t beam diagnostic light guide check garage door for binding.
Inspect each sensor to make sure the green or red power indicator lights are illuminated.
Allow roughly 10 minutes to troubleshoot your garage door opener.
It has an adjustable timer for setting when you want the lights to go off after opening or closing the garage door.
When your opener light stays on for more than the usual 4 minutes there are a number of reasons why.
What controls the lights.
If you hear a click replace the light socket.
Raise the garage door using the control button on the garage wall or the remote control unit from a vehicle.
Check for interference from adjacent photo eye sensors of any brand.
Many factors can damage the opener lights so be sure to check every possible failure.
If you do not hear a click replace the logic board.
If an operational problem exists and the garage door opener will not close the opener can be forced to close.
Listen for the light relay on the logic board to click.
When troubleshooting garage door opener light problems apply these steps to tackle the inconvenience.
This does not apply to wall mounted garage door openers that use a work light that is separate from the garage door opener.
Following these easy procedures won t take you much time.
It also has a dedicated light switch for turning on and off the lights without operating the garage door.
There is a timer for the lights that last 4 minutes.
Press and hold the wall console button until the garage door is completey closed.
When your garage door opener is not responding to any command from the remote or the door control you need to check if the opener has electricity.
The garage door opener light will flash twice and the down button will begin to flash.